Gearbox Conversion Session #6

HOME » Gearbox Conversion Session #6 (11 Slides)

[Page 1 of 1] :: Jump To

Up one level

DSCN1541 * Time to fix the bearing issue. Dad and I had removed some bolts, starter, exhaust and shaft.So pulling the box only took a few minutes. Note we use the jack under the motor to improve the angle. * Time to fix the bearing issue. Dad and I had removed some bolts, starter, exhaust and shaft.So pulling the box only took a few minutes. Note we use the jack under the motor to improve the angle. * 2288 x 1712 * (1.32MB)

DSCN1542 * Pulled apart. No need to move it out of the car 100%. * Pulled apart. No need to move it out of the car 100%. * 2288 x 1712 * (1.35MB)

DSCN1543 * Messy, but no damage. * Messy, but no damage. * 2288 x 1712 * (1.43MB)

DSCN1544 * Some metal back here. I cleaned everything out. * Some metal back here. I cleaned everything out. * 2288 x 1712 * (1.36MB)

DSCN1545 * As you can see, the backwards bushing was not working correct. * As you can see, the backwards bushing was not working correct. * 2288 x 1712 * (1.39MB)

DSCN1546 * This is the proper way. * This is the proper way. * 2288 x 1712 * (1.26MB)

DSCN1547 * Left is the Frontline supplied bushing. Right was the stock one. * Left is the Frontline supplied bushing. Right was the stock one. * 2288 x 1712 * (1.32MB)

DSCN1548 * Notice how tall the stock one is. I am going to use the top one. This will fix the clutch slave washer issue. * Notice how tall the stock one is. I am going to use the top one. This will fix the clutch slave washer issue. * 2288 x 1712 * (1.46MB)

DSCN1549 * Cleaned, oiled and ready. * Cleaned, oiled and ready. * 2288 x 1712 * (1.31MB)

DSCN1551b * Results. It took about 4 hours of work to pull, fix and reinstall all the kit. And it works, the clutch feels great and car moves. Yeah. * Results. It took about 4 hours of work to pull, fix and reinstall all the kit. And it works, the clutch feels great and car moves. Yeah. * 2288 x 1712 * (723KB)

DSCN1552 * Tuesday I will finish the tunnel mods off and make a piece to cover over the cut metal after the tunnel. Thanks Dad! * Tuesday I will finish the tunnel mods off and make a piece to cover over the cut metal after the tunnel. Thanks Dad! * 2288 x 1712 * (1.36MB)

Album last updated on Nov 12, 2006 - 02:03 PM

Powered by JAlbum 6.5 and BluPlusPlus skin

justdrive.ca